WL05 Driver Library – API Documentation

Header image

Main page


§ WL05_DrvIndicationCodes

Possible indication codes during the association process, retrievable by wl05_get_drv_indication.

Since
V0.80
Enumerator
NO_INDICATION 

Set at initialization

ASSOCIATED 

Module is associated (infrastructure mode)

IBSS_COMPLETE 

IBSS is created with no participant detected. This event is also generated, the device notifies (during a IBSS session), that previous detected IBSS participants are no longer avail.

IBSS_JOINED 

Module has detected a new participant at the IBSS

IBSS_ALONE 

The WL05 misses any participants at the IBSS

IBSS_LOSS 

The WL05 doesn't receive any beacons. Reconnect with wl05_disassociate and wl05_connect

MGMT_ERROR 

Internal protocol error occurred -> Restart (wl05_restart) required

MGMT_TIMEOUT 

Internal protocol error occurred -> Restart required

BAD_PARAMETERS 

Bad parameters specified by the executed API function

SCAN_FAILURE 

Scan failure occurred -> Restart required

SCAN_NOT_FOUND 

Requested (I)BSS was not found by scan

JOIN_FAILURE 

Join failure

JOIN_TIMEOUT 

Join timeout

AUTH_FAILURE 

Authentication error occurred

DEAUTHENTICATED 

Module was deAuthenticated by the access point

ASSOC_FAILURE 

Association failure occurred

DISASSOCIATED 

Module was disAssociated by the access point

WEP_PAIRKEY_FAULT 

Setting of WEP pair key failed

WEP_GROUPKEY_FAULT 

Setting of WEP group key failed

DISCONNECTED 

Device is not associated

TARGET_HUNG 

The WL05 is not accessible by the host driver -> Restart required

KEEPALIVE_FAULT 

The host driver has detected a keepalive check timeout -> Restart required






Top of page | Main page

Copyright © 2016 Beck IPC GmbH
Generated by Doxygen 1.8.12