CHIP.INI [TELNET]

---

[TELNET]
ENABLE=0/1

Define if the Telnet server should be activated. Use 0 to disable, 1 to enable.

BIOS_Server_On_Off() may be used to enable the server if disabled at startup due to this CHIP.INI entry.

Default:

If safe mode is off, the Telnet server is enabled per default. If safe mode is on, the Telnet server is disabled per default.

Example:

 [TELNET]
 ENABLE=0

Since:

SC2x3 V1.00

---

[TELNET]
PRIO=prio

Defines the task priority of the Telnet server task (TELN). Allowed value are 2-127.

Default:

Default priority is 38.

Example:

 [TELNET]
 PRIO=10

Since:

SC2x3 V1.00

---

[TELNET]
TELNETPORT=port

Sets the port number of the Telnet server.

Default:

Default Telnet port is 23

Example:

 [TELNET]
 TELNETPORT=5000

Since:

SC2x3 V1.00

---

[TELNET]
TIMEOUT=minutes

Telnet session will automatically close after TIMEOUT minutes without any characters received from the client. A TIMEOUT setting of zero means no timeout.

Default:

Default is no timeout.

Example:

 [TELNET]
 TIMEOUT=5

Since:

SC2x3 V1.00

---

[TELNET]
LOGINDELAY=0/1

Define if the delayed login of the Telnet server should be activated.

Use 0 to deactivate, 1 to activate. The delay time starts with 400 milliseconds. After each following failed login the delay time will be doubled until it reached 20 seconds. After successful login the delay time will be set back to 400 milliseconds.

Default:

By default, the delayed login is enabled.

Example:

 [TELNET]
 LOGINDELAY=0

Since:

SC2x3 V1.00

---

[TELNET]
LOGINRETRIES=number of login retries

Defines the number of login retries until Telnet session will be closed.

Default:

The default value is 5.

Example:

 [TELNET]
 LOGINRETRIES=3

Since:

SC2x3 V1.00

---

[TELNET]
USERx=user name

Defines a user name for Telnet. You can define a USER0 and a USER1.

You must specify both the user name and their password. Both user name and password are case sensitive. Maximum user name size: 19 characters.

Important notice:

To avoid security leaks you must define both user names and passwords.

Default:

Default user is 'tel'.

Example:

 [TELNET]
 USER0=user0
 PASSWORD0=pass0
 USER1=user1
 PASSWORD1=pass1

Since:

SC2x3 V1.00

---

[TELNET]
PASSWORDx=password

Define the password for a Telnet user. You can define a PASSWORD0 for USER0 and a PASSWORD1 for USER1.

Both user name and password are case sensitive. Maximum password size: 19 characters.

Default:

Default password is 'tel'.

Example:

 [TELNET]
 USER0=user0
 PASSWORD0=pass0
 USER1=user1
 PASSWORD1=pass1

Since:

SC2x3 V1.00